Install Corepad Grips on Razer Deathadder V4 Pro

Quick answer

Clean your Deathadder V4 Pro thoroughly, align the Corepad Grips precisely, and press firmly from the center outward to avoid bubbles.

Installation steps

1. Clean the mouse surface: Wipe the Deathadder V4 Pro with a microfiber cloth and isopropyl alcohol (70% or higher). Remove all oils, dust, and residue. Let it dry completely for 2–3 minutes. Skipping cleaning is the most common cause of poor adhesion.
2. Peel and align the first grip piece: Start with the left or right side grip. Peel the backing off one corner, align it with the mouse's edge, then slowly peel the rest while pressing the grip down. Do not stretch the material. Once the adhesive touches the mouse, it is hard to reposition. Dry-fit the piece first without removing the backing.
3. Press from center outward: Use your thumb or a soft card to press the grip from the middle toward the edges. This pushes air out and prevents bubbles. If a bubble remains, lift the nearest edge slightly and re-press. Do not poke the grip.
4. Repeat for remaining pieces: Apply the other side grip, then the top or button pieces if included. Follow the same clean, align, and press method for each. Work in a dust-free room. A single dust speck under the grip can create a bump.
5. Let the adhesive cure: Wait at least 6 hours before using the mouse. For best results, leave it overnight. This allows the adhesive to bond fully. Using the mouse too early can shift the grip or cause edges to lift.

What you need

• Corepad Grips - Razer Deathadder V4 Pro: Corepad Grips for Razer Deathadder V4 Pro are designed to fit the mouse's contours and provide a non-slip surface even for sweaty hands. The pre-cut shape saves you from trimming, and the soft material improves grip without adding bulk.