Razer Viper V3 Pro용 Jade ULTRA 스케이트: 글라이드 가이드

Quick answer

Jade ULTRA Skates replace the stock feet on your Razer Viper V3 Pro for a smoother, quieter glide. Follow the steps below to install them correctly.

Installation steps

1. Remove the old skates: Peel off the stock feet from the bottom of your Razer Viper V3 Pro. They are held on by adhesive, so start from one corner and pull slowly. If they resist, use a hairdryer on low heat for a few seconds to loosen the glue. Common mistake: pulling too fast can tear the old skates and leave residue. Work slowly.
2. Clean the mouse base: Wipe the exposed plastic base with a lint-free cloth and isopropyl alcohol to remove any adhesive residue or dust. Let it dry completely for about 30 seconds. Checkpoint: any leftover glue will prevent the new skates from sticking evenly.
3. Apply the Jade ULTRA Skates: Peel the backing from one Jade ULTRA Skate and align it with the front or rear of the mouse foot area. Press it down firmly, working from the center outward to avoid air bubbles. Repeat for the remaining skates. Common mistake: misaligning the skate can cause it to peel off later. Use the original outline as a guide.
4. Test the glide: Turn your mouse on and move it across your mousepad. The skates should feel smooth and quiet. If they catch or feel uneven, recheck the alignment and press down any lifted edges. Checkpoint: if the glide is still rough, the surface may need cleaning or the skates may need a few hours to settle.

Product facts

• Jade ULTRA Skates - Razer Viper V3 Pro: Jade ULTRA Skates are replacement mouse feet made for the Razer Viper V3 Pro. This listing is for the Standard option, SKU XR-JUS-VV3-022. They are designed specifically for your mouse model, so you get a precise fit without any cutting or adhesive.