Corepad Skatez for Ninjutso Sora: Large Size Fit Guide
By Lethal Gaming Gear | Published: 2026-10-27
Category: Product Reviews
Learn how to install Corepad Skatez large size on Ninjutso Sora, Sora 4k, and Sora v2. Step-by-step instructions with common mistakes to avoid.
Quick answer
Corepad Skatez in large size fit the Ninjutso Sora, Sora 4k, and Sora v2 perfectly. The 0.70mm PTFE skates replace the stock feet for a smoother glide, and installation takes about 10 minutes.
Why choose the large size Corepad Skatez
The large size Corepad Skatez come as a pack with two full sets, so you have spares or can outfit two mice. They use 100% pure PTFE for a consistent, low-friction glide that many gamers prefer over stock skates. The 0.70mm thickness is slightly thicker than some stock feet, which can help prevent the mouse base from scraping on soft mouse pads.
These skates are designed specifically for the Ninjutso Sora shape and also fit the Sora 4k and Sora v2 without modification. The high-quality 3M adhesive ensures they stay put once applied.
What you need before starting
You'll need the Corepad Skatez large size pack, a clean workspace, a microfiber cloth, and isopropyl alcohol (70% or higher) to clean the mouse base. A plastic spudger or guitar pick helps remove old skates without scratching the plastic. Avoid using metal tools near the sensor lens.
Make sure the mouse is powered off and the battery is disconnected if possible. This prevents accidental clicks during the process and protects the electronics.
Step-by-step installation guide
- Remove old skates: Heat the stock skates gently with a hairdryer for 15-20 seconds to soften the adhesive. Use a plastic spudger to lift an edge and peel the skate off slowly. Avoid bending the skate sharply—it can leave adhesive residue. If residue remains, apply a drop of isopropyl alcohol and rub gently with a microfiber cloth.
- Clean the mouse base: Wipe the recessed skate areas with isopropyl alcohol on a lint-free cloth. Let the alcohol evaporate completely for 2-3 minutes. Any moisture or oil will prevent the new adhesive from bonding. Do not touch the cleaned surface with your fingers—skin oils reduce adhesion.
- Apply the new Corepad Skatez: Peel the backing from one large Corepad Skate. Align it carefully with the recess on the mouse base—the shape is symmetrical so orientation matters. Press firmly from the center outward for 10 seconds. Repeat for the remaining skates. If the skate is misaligned, lift it immediately with a plastic tool and reposition. Once pressed firmly, the 3M adhesive makes repositioning difficult.
- Break in the skates: Place the mouse on your mouse pad and move it in figure-eight patterns for 2-3 minutes. This distributes the PTFE evenly and smooths out any initial scratchiness. The glide will improve noticeably after 30 minutes of use. If you feel uneven friction, check that all skates are fully seated and not catching on the mouse pad edge.
Product facts
- Corepad Skatez - Ninjutso Sora / Sora 4k / Sora v2 (Large Size): 1 pack contains 2 sets of Skatez. Corepad Skatez consists of 100% pure quality PTFE. Thickness: 0.70mm. Two sets per pack give you a backup or allow you to equip two mice, and the 0.70mm thickness provides a slightly raised glide that clears most mouse pad surfaces.
Corepad Skatez - Ninjutso Sora / Sora 4k / Sora v2 (Large Size)
