Corepad Skatez for Zowie EC1-B EC2-B: Glide and Fit Guide

By Lethal Gaming Gear | Published: 2026-10-29

Category: How-to Guides

Step-by-step instructions to install Corepad Skatez on Zowie EC1-B and EC2-B mice, with tips on fit, glide, and common mistakes.

Quick Answer

Corepad Skatez for Zowie EC1-B and EC2-B offer a smooth, consistent PTFE glide with easy drop-in installation. Follow these steps to replace your stock skates and avoid common fit issues.

Why Replace the Stock Skates?

The Zowie EC1-B and EC2-B come with adequate stock skates, but many gamers find them too slow or inconsistent after extended use. Corepad Skatez use 100% pure PTFE for a more controlled yet faster glide, and the 0.6mm thickness matches the original height, so you won't need to adjust your mouse feet or sensor distance.

What to Expect from Fit

Corepad Skatez are precision-cut to match the EC1-B and EC2-B's skate recesses exactly. The set includes two complete sets, so you get spares or can outfit two mice. The 3M adhesive holds firmly, but proper surface prep is critical for long-term adhesion.

Installation Steps

1. Clean the Skate Recesses: Remove the old skates and use a plastic spudger or your fingernail to peel them off. Clean the recess with isopropyl alcohol and a lint-free cloth. Let it dry completely. Any grease or residue will prevent the adhesive from bonding. If the old adhesive is stubborn, use a bit more alcohol and a soft eraser.
2. Align and Press the New Skate: Peel the backing from one Corepad Skate. Align it carefully with the recess — the skate should sit flush without overhang. Press firmly from the center outward for 10 seconds. Do not touch the adhesive side with your fingers. If the skate is misaligned, lift it gently with tweezers and reposition immediately.
3. Repeat for All Skates: Install the remaining skates (front, rear, and ring if applicable) using the same method. Ensure each skate is fully seated in its recess. The EC1-B and EC2-B use three skates. Double-check that the ring skate is oriented correctly — it's not symmetrical.
4. Apply Even Pressure: Place the mouse on a flat surface and press down firmly on each skate area for about 30 seconds. Use a soft cloth to avoid scratching the skates. Skipping this step can lead to uneven glide. The adhesive needs pressure to bond fully.
5. Break In the Skates: Move the mouse on your mousepad for 5–10 minutes with moderate pressure. This helps the PTFE settle and removes any microscopic high spots. The glide will feel slightly slower initially. After break-in, the pure PTFE will deliver its characteristic smooth, controlled speed.

Product Details

Corepad Skatez - Zowie EC1-B / EC2-B: Corepad Skatez consist of 100% pure quality PTFE with a thickness of 0.6mm. The pure PTFE material delivers a smooth, consistent glide, and the 0.6mm thickness matches the stock skate height, so no sensor calibration is needed.
Corepad Skatez - Zowie EC1-B / EC2-B