VAXEE NP01S YanZi Q Skates: Fit, Install and Glide Guide

By Lethal Gaming Gear | Published: 2026-10-31

Category: How-to Guides

A step-by-step guide to fitting, installing and tuning ESPTiger YanZi Q PTFE skates on the VAXEE NP01S, with checkpoints to avoid common mistakes.

Quick answer

Use ESPTiger YanZi Q PTFE skates made specifically for the VAXEE NP01S. Clean the original feet completely, dry-fit the new skates before peeling the adhesive, and press them on with even pressure so the PTFE sits flush.

Why the YanZi Q fit matters on the NP01S

The NP01S has a compact, symmetrical shape with a low-profile base, so skate thickness and edge alignment affect how the mouse sits and moves. YanZi Q skates are cut for the NP01S, which removes the trimming and guesswork that universal dots or sheets require.

If a skate overhangs the edge or sits unevenly, you may feel a scratch or a dead spot in the glide. Taking a minute to dry-fit before sticking avoids that.

When to replace and what to expect

Replace your skates when you see visible wear, a rough edge, or a glide that feels inconsistent across the pad. A fresh PTFE set restores a smooth, predictable feel, but it will not change the mouse's weight or sensor performance.

YanZi Q skates are pure PTFE and designed for smoothness and precision. Expect a clean, consistent glide rather than a dramatic speed change; pad choice still has the biggest effect on overall feel.

Step-by-step installation

Remove the old skates: Peel off the worn feet slowly, using a plastic tool or your fingernail. Work from one corner and keep the tool flat against the base. Checkpoint: if adhesive remains, do not scrape with metal; move to the cleaning step.
Clean the base: Wipe the skate recesses with isopropyl alcohol on a cotton swab and let them dry completely. Remove all old adhesive residue. Checkpoint: any leftover residue will create a high spot, so the surface must feel smooth and dry before you continue.
Dry-fit the new skates: Place the YanZi Q skates into the recesses without removing the backing. Confirm each skate sits flush and does not overhang the edge. Checkpoint: if a skate does not sit flat, stop and check for residue or a misaligned recess before sticking.
Peel and apply: Peel the backing from one skate at a time and set it into place. Press evenly with your thumb for a few seconds, then repeat for the others. Checkpoint: avoid touching the adhesive side; oils from your fingers weaken the bond.
Press and settle: Place the mouse on a clean pad and press down gently while sliding it a few centimeters in each direction. This seats the adhesive evenly. Checkpoint: do not use heat or excessive force; firm, even pressure is enough.
Test the glide: Use the mouse normally for a few minutes. Listen for scratching and feel for any dead spots or tilt. Checkpoint: if you feel a scratch, re-check that the skate is fully seated and free of debris.

Product facts

VAXEE NP01S YanZi Q: ESPTiger YanZi Q PTFE skates are designed specifically for the VAXEE NP-01S. You get a direct fit without trimming, which reduces the chance of uneven edges and inconsistent glide.
VAXEE NP01S YanZi Q