Esports Tiger YanZi for Razer Deathadder V3 Pro: Glide and Feel

By Lethal Gaming Gear | Published: 2026-10-24

Category: How-to Guides

Learn how to replace the mouse skates on your Razer Deathadder V3 Pro with Esports Tiger YanZi for a smoother, more controlled glide. Step-by-step guide with tips.

Quick answer

Replace the stock skates on your Razer Deathadder V3 Pro with Esports Tiger YanZi for a noticeably smoother glide and better control. The 2.5D curved edges reduce wear, and the high-purity PTFE material glides consistently.

Why choose YanZi for this mouse

The Esports Tiger YanZi series uses a specially adjusted high-purity PTFE material with a smooth, flat surface. The 2.5D curved edge protects the mouse pad from wear and reduces friction. This gives the Deathadder V3 Pro a glide that feels both fast and stable, especially during quick flicks.

Compatibility note

The YanZi for Deathadder V3 Pro is designed specifically for this mouse shape. The anti-collapse filling provides better support, and the 3M adhesive ensures a strong hold. However, the adhesive is permanent once pressed, so alignment must be exact.

Step-by-step replacement guide

Step 1: Prepare your tools: You need a clean workspace, a heat source (hair dryer or heat gun on low), a plastic pry tool or thin guitar pick, and isopropyl alcohol with a lint-free cloth. Avoid metal tools that can scratch the mouse or skates.
Step 2: Remove the old skates: Gently heat the stock skates with the hair dryer for 15-20 seconds to soften the adhesive. Insert the pry tool under the edge and slowly lift. Do not pull quickly or the adhesive may tear and leave residue. If the skate bends, reheat and try again. Bent skates cannot be reused.
Step 3: Clean the skate area: Wipe the exposed area with a small amount of isopropyl alcohol and a lint-free cloth. Let it dry completely for 2 minutes. Any dust or oil left under the new skates will cause uneven glide. Do not use soap or water; alcohol evaporates cleanly.
Step 4: Align and apply the YanZi: Peel the 3M adhesive backing from one corner. Use the original skate shape as a reference for position. Lower the skate straight down without sliding. Once the adhesive touches, it bonds instantly. Press from the center outward to avoid air bubbles.
Step 5: Press and cure: Firmly press each skate with your thumb for 30 seconds. Then let the mouse sit untouched for 1 hour. The anti-collapse filling provides support, but the adhesive needs time to reach full strength. Using the mouse immediately can shift the skates.

Product details

Esports Tiger YanZi - Razer Deathadder V3 Pro: Specially adjusted colorful high-purity PTFE material, with a smooth and flat surface. 2.5D curved edge protects the mouse pad from wear and reduces friction. The high-purity PTFE delivers a consistent glide, and the curved edge extends the life of both the skates and your mouse pad.
Esports Tiger YanZi - Razer Deathadder V3 Pro